Bilal T.

I am a professional Electronics Engineer with 9 years of experience in the Embedded System Software and Hardware R&D industry. My expertise range from hardware design with firmware development to the integration of hardware with software(Web. IOS, Android). I strive to provide low-cost embedded solutions. My knowledge of engineering specifications that rule each production stage is well defined, and I take pride in my ability to work in sync with resources and people ⚡Expertise in Hardware Design & PCB Design⚡ ✅Schematic Capture and PCB Design by using the Altium Designer, Eagle, Ki-cad. ✅High-speed complex PCBs. ✅PCBs with FPGAs, Processors, DDR2, DDR3, PCIe, HDMI, Ethernet, USB 3.0. ✅PCBs with SPI, I2C, RS232, RS485, RS422, CAN, USB, UART Protocol circuits. ✅Design Layout for 4G/LTE, Wi-Fi Module, Bluetooth, GSM/GPS, LoRa, Zigbee. ✅Differential signal and transmission line routing. ✅Impedance calculation & Stack-up Building. ✅Knowledge of EMI/EMC and CE certifications. ✅EMI/EMC Compliant Design ✅RF PCBs with Rogers & FR-4 with complete impedance calculation. ✅Digital & Analog(Mix signal PCBs). ✅Power Electronics circuit design. ✅Multi Stack boards enclosed in casings. ✅Shields of all Arduino boards and Raspberry Pi boards. ✅IoT PCBs with NB-IoT Processor chip i.e. NRF9160. ✅Biomedical-related sensors circuit board design. ✅MEMS / IMU Sensors circuit board design. ✅Motor Control circuit boards design. ✅NFC, RFID, and biometric circuit boards design. ✅Enclosure, 3D modeling, Rendering in Solid works. ✅Product Prototyping as well as preparing for manufacturing ✅Reverse Engineering of PCBs. ✅Consultancy and technical support of PCB fabrication and assembly. ⚡Expertise in Embedded Firmware Development⚡ ✅Exceptional C++/C /C# and Python programming skills. ✅FPGA design using Verilog/VHDL (Xilinx ISE). ✅Boards (ARM, TI, ST, Microchip, Atmel, DSP, Arduino, etc.) ✅Embedded software: Keil, Eclipse, Segger, Zyhper, Atmel Studio, Arduino, Node-Red. ✅Single board computer: Raspberry Pi, Beaglebone, NanoPi. ✅Strong with UART, I2C, SPI, BLE, BT, GSM/4G/LTE/GPRS/GPS, ZigBee, LORAWAN. ✅Strong with BLE HM10, HC05,ESP8266, ESP32, DA14580, nRF52,nRF9160. ✅Strong with RS232, RS485, RS422, CAN, USB2.0, USB3.0. ✅OBD Protocols SAEJ1850PWM, SAEJ1850VPW, ISO14230-4 (KWP2000),ISO15765-4. ✅IoT development using MQTT. ✅Expert in AWS IoT Core and Azure IoT Core ✅IoT Development in NODE RED Environment on Raspberry Pi(Raspbian). ✅Experience in NRF connect. I am hoping to be hired by you to bring your project to completion in the least time with a nominal price by using My skills and experience. If given a chance to do this task, I will work best and bring in the required output.