Hop D.

I am an experienced hardware design engineer with 5 years's experience of desgning schematic and pcb. The products: 1, The Telecommunication device (RRU Unit): - Design with Xilinx's FPGA: Ultrascale MPSoc Xilinx, STM32F7 and PIC32 - NOR, NAND flash, RAM: DDR3, DDR4 - High-Speed Interfaces: PHY Ethernet 100/1000, PCIe, CPR - Low-speed interface: SPI, I2C, RS485 -Single to 20 layer PCB Designing - Work with manufacter to make pcb and pcba - Knowlegment about signal integrity and power integrity simulation for project to evaluate performance of circuit 2. The Mainboard for X-ray Detector - FPGA: the Zynq 7 and Artix 7 - RAM: DDR3 - High-speed Interface: USB 3.2 (5Gbps) - Using board to board connector (Mate daughter board vs Mother board) 3. The spectrometer: - Use STM32L4 and STM32H7 to control CCD sensor and InGaAs Linear Sensor - Design Analog-Front End for CCD and InGaAs sensors. - Using Bluetooth to transfer data. 4. LED Driver - High Accuracy (more than 98%) - Current Level: 100mA, 2A. 5. Artix 7 - TI AFE2256 Transceiver Project - Readout 256 channels/ROIC and 12 ROIC - Combine with Gate Timing to capture the image