Phuc H.

Hi. I'm Daniel Huynh and 5+ years of experiences in Embedded Hardware Design worked for different domains like E-mobility, IoT and Power Supply/Charger product. 1. EXPERIENCE SKILLS - Electric vehicle systems (E-Bike and E-Scooter) including battery management, BLDC & PMSM motor drivers, high reliability Vehicle Control Units [VCUs], communications via network standards and CAN Bus. - Experience in architecting, designing and testing mixed signal electronic systems combining embedded microcontrollers, analog, digital and power driver IC’s and communications. 2. HARDWARE DESIGNER SLKILL + Good knowledge of electronics component concept, topology, reference design and related application. + Reverse Design from the key component/the picture reference. + Calculations and simulations tool (LTspice, TINA-TI, MPSmart, Matlab/Simulink ...) + Schematic Design (Name in rule, Design rule check ...) + Multi-layer PCB Design (Clock signals, Differential pair, Noise , Power High Voltage/Current consideration, Antenas and RF layout ...) + Panel and Gerber PCB design, DFA, DFM, and PCB manufacturing and assembly processes.(JLPCB/PCBway/ The other China PCB manufacturing). + Bill of Material and Design to cost product (Digikey/Mouser/JLCPCB/LCSC/AVNET/FARNELL and the other distributor/sourcing from China ) + Excellent EDA tool (Altium Designer, Kicad, Pulsonix, Eagle, EasyEDA, Altium365/CircuitMarker...) + EMI/EMC and the functional safety requirement for E-mobility, IoT, Consumer and Power Supply/Charger product 3. WORK EXPERIENCE - Microprocessor circuit: + STM8/STM32G/STM32F/STM32H series (ST) + XMC14xx Series (Infineon) + TMS320F28xxx series (TI) + S32K1xx series (NXP) + EFR32xx series (Silab) + ATMega2560 (Arduino Mega) + nRF52840, nRF5340 ... (Nordic ) + MS51FB9AE...(Nuvoton) - Power supply: DC-DC (isolated, Flyback, Boost, Buck, LDOs…). - Protocol/communication: + SPI, I2C, RS485, RS232, CAN, Modbus TCP/IP, RTU, Ethernet ... + Wireless, IoT: Z-wave, Wifi, Bluetooth 4/5, GSM (3G, 4G/LTE), Lora...