Manuchehri Raxmonov E.

I am a Senior Power Systems Engineer specializing in **grid interconnection, compliance, and system impact studies** for **renewable generation, BESS, hybrid plants, conventional generation, and large industrial / data center loads**. I deliver **utility-, ISO-, and TSO-ready studies** using **PSS®E, PowerFactory, PSCAD, and ETAP**, covering the full range of technical assessments required for project development, connection applications, design review, and compliance demonstration. My work supports **Solar PV, Wind, BESS, Hybrid plants, conventional power facilities, and data centers**, with studies prepared in a way that reflects how utilities and system operators actually review **models, assumptions, plots, test evidence, and compliance conclusions**. I support clients from early-stage screening through submission-ready packages, including clear RFIs, defensible assumptions, clean technical plots, and structured reports suitable for utilities, TSOs, ISOs, developers, EPCs, and owners’ engineers. Core Services Grid Interconnection & Compliance Studies * Load flow and operating case assessment * Short-circuit / fault level calculations * RMS dynamic stability studies * Grid code and interconnection compliance benchmarking * Utility / ISO submission-ready technical reports * Model review, validation, and technical support during review cycles ### Renewable Generation / BESS / Hybrid Plants * Solar PV, Wind, BESS, and Hybrid plant interconnection studies * LVRT / HVRT / LFRT / HFRT assessment * Reactive power capability and voltage control performance * Frequency response and plant controller performance * Weak-grid assessment and control interaction review * PRC / MOD / MQT / G99 / G5 compliance support ### Data Center & Large Load Studies * Grid connection studies for **large industrial loads and data centers** * Load flow, contingency, and thermal capacity assessment * Point of interconnection screening and transfer capability review * Motor starting / dynamic load behavior review where applicable * Voltage stability and reactive power performance assessment * Large load ride-through and dynamic behavior assessment * Support for connection strategy, substation concept review, and utility-facing technical documentation ### Design & Engineering Support * Single-line diagrams (SLD) * Cable and conductor sizing * Grounding / earthing grid studies * Surge arrester selection and insulation coordination * Protection coordination and selectivity studies * Relay setting review and interface logic support ## Technical Services ### Short-Circuit Studies * Fault calculations to IEC 60909 and IEEE methods * Breaker duty and X/R ratio verification * IBR fault contribution assessment * Faulted operating condition evaluation ### Dynamic (RMS) Studies * Transient stability and oscillatory damping * Frequency response and control performance * LVRT / HVRT / LFRT / HFRT benchmarking * Weak-grid and controller interaction studies * Plant controller and model tuning support ### EMT Studies * IBR control interaction and converter dynamics * Fast transient and weak-grid EMT validation * Special operating scenarios and black-start studies where required * OEM / utility EMT model review and benchmarking ### Protection & Control Interface * Relay coordination support * PRC-019 interface checks * Voltage / frequency protection coordination with IBR controls * SCADA / Modbus / IEC 61850 signal and interface logic review ## Grid Codes & Standards Experience **United States** NERC PRC(029 024 019) & MOD(025 026 027 032) standards, ERCOT, PJM, NYISO, MISO, SPP, CAISO IEEE 519, IEEE 1453, IEEE 1547 ERCOT model quality and interconnection processes **United Kingdom** ENA G99 ENA G5/5 P28 / P29 DNO submission and acceptance support **Germany / EU** VDE-AR-N 4110 / 4120 FGW TR3 / TR4 / TR8 references Additional regions can be supported based on project documentation and applicable grid-code requirements. ## Software * PSS®E * DIgSILENT PowerFactory * PSCAD * ETAP * MATLAB / Simulink * AutoCAD ## Deliverables * Technical reports * RAW / DYR files * PowerFactory projects * PSCAD cases * ETAP models * Parameter summaries * Validation plots * Submission support documents ## Why Clients Work With Me * Clear scope definition from the start * Strong RFIs and efficient data collection * Technically defensible assumptions * Utility-ready reports and plots * Combined RMS and EMT capability I can support complete interconnection packages or single-study scopes, depending on project needs. If you have an RFP, grid-code requirement, interconnection document, utility feedback package, or study scope, I can review it and help define a clear technical approach, deliverables list, and schedule.